Fiberglass Helmet question

obi sean kenobi

Well-Known Hunter
Just got my new fiberglass bucket in the mail. Im a little concerned though. The visor area has been cut out and one of the mandibles is pushed in - thus throwing off the shape of the whole t visor/eye area.

How do I re-position it? If I move it in too place it just snaps back into the pushed in/f*#%ed up position.

Thanks in advance,
sean
 
Same here, once I put in the visor it was perfect. Maybe you should post a picture of your helmet so we can see how much the mandamble is off.

If that won´t help, you could cut out a small steel rod and but it inside the mandable. I had already bought be a small steel rod and I had cut it in the desired length, but in the end I didn´t have to use it because the visor corrected the shape.
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top