Fett helmet off the bay NEEDS CPR

Red5sixx

New Hunter
So a friend of mine wanted a fett bucket so he bought on off the bay..BAD IDEA!. He brought it to me to see if I can fix it. I guess my question is does anyone have some ideas or should I thrash it buy one and cast it for him. Any help?

Is it me or does the helmet look wavy?

fett4.jpg


fett3.jpg


fett2.jpg


fett1.jpg
 
That is an MSH recast that's been floating around. I have to say, that one is the worst I've seen yet.

Unfortunately, because it's a resin slush cast, there won't be anything you can do to straighten the
sink holes with a heat gun. It will creep back as soon as you expose it to a hot day in a car, even
if you can get it straight without cracking it. Your best best is to bondo fill the low spots
and glaze. You can likely still make a paintable helmet with a fair amount of umph, but it will never
be quite right. Also, be careful buying one and "casting" it. That's mirky water there.


:cheers



So a friend of mine wanted a fett bucket so he bought on off the bay..BAD IDEA!. He brought it to me to see if I can fix it. I guess my question is does anyone have some ideas or should I thrash it buy one and cast it for him. Any help?

Is it me or does the helmet look wavy?
 
Thanks FP...I figured as much. Guess I'll try to build it up and do
what I can. This is by far the worse cast I've seen. I might just cut out the back
vent and fab one. We will see I'll post my progress thanks for the help.

Red


That is an MSH recast that's been floating around. I have to say, that one is the worst I've seen yet.

Unfortunately, because it's a resin slush cast, there won't be anything you can do to straighten the
sink holes with a heat gun. It will creep back as soon as you expose it to a hot day in a car, even
if you can get it straight without cracking it. Your best best is to bondo fill the low spots
and glaze. You can likely still make a paintable helmet with a fair amount of umph, but it will never
be quite right. Also, be careful buying one and "casting" it. That's mirky water there.


:cheers
 
Thanks so much. Yours came out really well. The only problem I am
going to have is the ear pieces are in bad shape, they are way to thin and he didn't get the range finder.
Anyone know where I can get one?




Wow, thats the same bucket I bought, only like fettpride said, its in much worse condition. I kinda feel lucky that mine wasnt so warped, although I did have to fix the gash in the back, here's the link to what I did with it: http://www.thedentedhelmet.com/f23/another-boba-fett-helmet-wip-43653/

And some pics of what it could look like
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top