ESBkillmarks

BANDITZ

BANDITZ

Hunter
Can any body advise me on the ESB Killmarks...i see a lot of helmets with 14 - 18 stripes.......i was going to do 14 stripes i just need the size in mm...cheers
 
Actually, this is a good question as I have yet to put mine on. I'm doing the Jedi bucket, but the last time I tried to do kill makrs, the paint bled through and made a mess. How do I keep the paint from bleeding through the tape?
 
Are you airbrushing? or spray painting? Either way a light coat of clear over the masking tape will help seal it. Then spray a couple light coats of the paint as opposed to one heavy coat. I have used this technique on models for years with great results. Practice first.

Good luck.
Hope that helps.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top