Esb helmet first ever paint job.

shipmal

New Hunter
Just looking for some feedback on my first attempt at an ESB paint job. Thanks

IMG_6427-1.jpgIMG_5842-1.jpgIMG_5844-1.jpgIMG_5845-1.jpgIMG_5847-1.jpg$_57.jpg

- - - Updated - - -

Massive thanks to whoever did the stencils I used, the welsh warrior for help and advise, and everyone else for tips ive picked up through reading the posts. Really is a smart and helpful community.
 
Good spot Lazarus, yeah its the RS prop masters bought and started this at the end of 2013, put it to the back burner after doing all the main airbrushing and just finished all the niggly little things recently. The Inside liner is off the guy on Ebay who sells them from Argentina, I few little alterations and it really sets off the interior also making it a really snug comfortable fit. Any ideas if this is 501st quality? Cheers
 
Not 100% happy with the back panels but they were the beginning and the first time Id ever used an airbrush or did anything like this. The rest became much easier as the experience grew. learnt a lot through the process which will help me on my next one.
 
impressive! looks great bro! definitely a 501st candidate. you'd only want to replace the green visor with a smoke colored visor if you wanted level 2 certification but i think you'd be ok for basic approval.


Sent from my R2 unit
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top