Hey guys, I am hoping that one of you electronic guru's could help me out. I just bought a helmet that came with a hyperdyne labs servo controller board and also a RF reciever and transmitter (Except I do not think that part is hyperdyne labs).
I am so puzzled on how this thing works and am just trying to figure out the basics. I was wondering if anyone had a close up picture of where their servo controller board wires connect into the RF transmitter board. I was told by the previous owner that the problem was with the reciever and transmitter, so If the wires are in the correct spot and it doesnt work then I will get another reciever and transmitter board (I can get one cheaper then at hyperdynes, and just do the wiring myself). If anyone could take a pic of what wires go where you will be my hero! Thanks for any help!
Heres a pic of everthing.
And this is where I am trying to find out what wires go where. I took them out of each spot and plan to reinsert them when I find out where each one properly goes. Thanks again!