Dent

  1. #1
    frb13's Avatar
    Member Since
    May 2007
    From
    so. cal
    Posts
    292

    Dent

    Does anyone know the circumference of the dent? I need to make one in my helmet. Thanks

  2. #2

    Re: Dent

    That might depend on how big of a helmet you have to start with. I noticed My ASOK CC dent is wider then the Stencils from RafalFett's templates. Not by much but enough to need to adjust the templates a little. I know Bill said that it was a larger helmet too so you might need to measure it so someone with a helmet that size could give you a close measurement. Or im sure someone on here has the correct size from the actual screen used helmets.

  3. #3
    RafalFett's Avatar
    Member Since
    Oct 2010
    From
    Galati, Romania
    Posts
    2,609

    Re: Dent

    Around 30mm X 30mm is the dent size on the RWH v2 templates; read more here ==> Rafal Works Helmet (RWH) v2 Helmet Templates and Build, especially at the end of the first post.

  4. #4
    frb13's Avatar
    Member Since
    May 2007
    From
    so. cal
    Posts
    292

    Re: Dent

    Thank you! Just what I needed.

Similar Threads

  1. Dent Templates?
    By darthbailey58 in forum Boba Fett Costume
    Replies: 4
    Last Post: Feb 14, 2012, 1:06 AM
  2. Question: Most Accurate Dent
    By Kwally89 in forum Boba Fett Helmet
    Replies: 8
    Last Post: May 31, 2009, 1:42 PM
  3. Question: Dent Position
    By no good to me dead in forum Boba Fett Helmet
    Replies: 1
    Last Post: Nov 6, 2008, 10:24 PM
  4. Who/what is THE DENT?
    By Art Andrews in forum Site Support & News
    Replies: 59
    Last Post: Dec 6, 2007, 7:51 PM
  5. DENT ALWAYS THERE!!!!!
    By BobaFettSlave_1 in forum Jango Fett Costume
    Replies: 55
    Last Post: Jan 10, 2006, 7:09 PM
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •