bucket panels

albertabeeffett

New Hunter
im looking for measurements for all of the panels that make up the full shape of a dp 95 helmet. I want to make one out of sheet metal but i have no references to go off of. if anybody would have anything that would help it would be greatly appreciated.
 
Hey albertbeefett

I will take some measurements today for you. my 95 is a little warped but hopefully they should be of help.

Randy :jet pack
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top