Borden Connector

Well, I haven't bought one yet, but I'd suggest the three hole from the KAB Dental site. Their site has been referenced several times here when others have asked about where to buy from, they are less expensive, AND they have big, clear color pictures!

Just my opinion.
 
Can anyone order one for me? Unfortunately I don't have the means to get one sent to the UK:cry

Thanks

Dan

Mandalore, did anyone help you out getting one of these yet ?
If not I can hook you up with ordering one since I'd like an actual connector as well. :)

LMK

~Mike
 
I've never actually dealt with a real Borden connector.
When you buy it, do you have to cut it down to install it?
I mean obviously from the picture you have to disassemble it to get the inner 3-hole piece isolated. But after that, do you have to cut it down?
 
How far out from the surface of the helmet is this supposed to stick out? It looks like about 1/16th of an inch or so?? It's not flush right?
J-ROCK
 
How far out from the surface of the helmet is this supposed to stick out? It looks like about 1/16th of an inch or so?? It's not flush right?
J-ROCK

Correct. It sits out from the surface a tiny bit.

I took mine apart when installing it so it didn't stick too far out inside. Then I just used goop from the inside to secure it.
 
$11? Try $3.18!
:D

Also, after cutting the connector down to the right size, remember that you have to FLIP it so the hole orientation is correct. The CUT side faces out, so don't screw it up! ;)

There was a thread back in 2002 - 2003 on how to do it... hmmm....
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top