BoBo lights and MSH2

Anyone have any trouble getting their Bobo lights to fit inthe RF from the MSH2? I can't seem to get mine even close to fitting in there...

How did you guys get yours to fit?

Mine fit fine. I just unplugged the leds, clipped the lines or whatever you call them (wire going to the led?????:lol ) quite a bit shorter, plugged the leds back in & worked good I'm still not quite shure what to do with the underneath green led though???

Are the LED's Bobo uses 5mm? or smaller?

the end on mine that the houses the green light and the battery are taller than the space they have to fit in. I didn't want to sand down to give them extra space until I checked with others. Worst comes to worst I can steal it from my DP and see if it fits there, it just won't be as good of a piece.

Quote:

---

Slowmo wrote:
the end on mine that the houses the green light and the battery are taller than the space they have to fit in.

---

Hmmm...I wonder if you have the same setup that I do?
I wish I could be of more help, but my camera really sucks:( ...as you can see-it was really cheap though:)


http://200.72.163.179/cdref/tdh/General/lights.JPG

http://200.72.163.179/cdref/tdh/General/lights2.JPG
Yeah, if you just keep triming and carefully bending the led leads with a needle nose you should be able to make the unit fit with the 2 red leds at least. For the grren one, I ended up drilling a hole through the main body of the RF into the clear part for about 1/16" In low light, the whole clear part glows green...It looks really cool. Again, wish I could show ya a detailed pic, but trust me...if you take your time & are carefull, you should be able to make them work