Boba's dent

dung0beetle

Active Hunter
I have been searching, but I can't seem to find much about the size and location of the dent. I have tried looking at source pics from people's helmets here, but they don't seem to be in the same position on the dome. Does it vary with the films?
 
Thanx, digifett... This is close to what I am looking for. I still need dimensions of the dent and something more detailed on where it is located on the helmet dome. I can eyeball it from what you have given me for my cardboard version, but I would like my sculpted helmet to be more accurate.

If anyone has an accurate(or as close as you can come), helmet, could you please measure the dent's diameter from the widest and smallest points. Also, from the brow ridge to the bottom of the dent.? I think that's all I need.

P.s. Please state whether it is Rotj or Esb.

Thank you
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top