Boba Helm Scratch Build - The Walrus Strikes Back (Pic Heavy)

Well. Hello again.

I started my Boba Helm a while ago, but got very busy and everything I was doing ground to a halt very suddenly.

First Thread

So here we go again, I'm back with thrusters on full.

Let's get started:

Whats been done since last update: Reshaped dome a little, completely reshaped back of helmet and visor area has warped a little. Nothing major. Oh and a coat of primer (Looks so much better with primer)

Attachment 67088
Attachment 67089
Attachment 67090
Attachment 67091

(More Soon)

Looking good!

UPDATE:

Hey again, did some work on the helmet a couple of nights ago. But was too busy to update:

Defined upper + Lower Cheeks. Applied p38 (Bondo) to craters and smoothed all over dome (Front and left side of dome are not shaped accurately as of yet) and back of helmet.

Attachment 67131
Attachment 67132
Attachment 67133

UPDATE:

I have done even more smoothing to back of helmet ready for lip and getting ready to cut out the rectangle for the grill/key holes:

I've applied P38 to make the lip, I'm going to sand it down to the right dimensions and then prepare to cut out the keyhole rectangle. Also I will straighten up the lip of the helmet all the way around.

Attachment 67134
Attachment 67135
Attachment 67136
Attachment 67137
Attachment 67138
Attachment 67139

looking good