BlackCatBone's GMH paint-up!

BlackCatBone

Active Hunter
Here's my final project photos for my ESB project. GMH helmet, with Bobamaker rangefinder (no RF came with my GMH). Used the layer method with Rusto paints. My goal (as with my RotJ helmet,) was not to 100% match the screen-used damage, but to get as close as I could "freehanding" it using photo refs. I'm a graphic designer, and it was important to have a little of my own spin on it.

This is my first ever ESB paint job.

I'm also a fan of a dirty bucket, so I may have grimed it up a little more than usual. More scratches, more smudges, but most helmets I see don't look "lived-in" enough for me. So I went full steam ahead.

If you'd like to see the entire step-by-step process, visit my BUILDING BOBA blog: http://buildingboba.blogspot.com/

I hope to have final photos of my full RotJ armor soon.

But without further ado...

BF_ESB_FINALS001.jpg


BF_ESB_FINALS002.jpg


BF_ESB_FINALS003.jpg


BF_ESB_FINALS004.jpg


BF_ESB_FINALS005.jpg


BF_ESB_FINALS006.jpg


BF_ESB_FINALS007.jpg


BF_ESB_FINALS008.jpg


BF_ESB_FINALS009.jpg


And here's my GMH ESB with my TerminalFettler RotJ!

BF_ESB_FINALS_both.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top