Attaching Rangefinder to Stalk

Skaught

Active Hunter
I have an aluminum "stalk" (is there a better term) and a resin rangefinder. What would be the best way to attach the rangefinder to the top of the stalk?

Thanks!

Scott
 
Screw it into the stalk.

Agreed. Drill 2 small holes through the bottom if the RF. Then Drill and tap 2 holes in the top of the stalk to match up the holes on the RF. Use 2 small screws inside the RF to screw into the stalk. It'll never come off unless you want it to...
 
I have a Sgt Fang, and i was wondering about how to attach the stalk, screw sounds good like stated. but i was wondering how exactly? i havent found a good size that doesnt leave the stalk securly fit. its either a tad to small or to big. and i worry that the screw will eventually just wear out the stalk with its egdes ( does that make sence??) i would like the stalk to stay up by it self, dont see that happen even with the right sized screw.
267343_10150265276846938_513686937_8044683_7110700_n.jpg293025_10150265277496938_513686937_8044687_4038484_n.jpg
 
I used a screw with a flat head and wingnut. Fett_MD

I need a way to keep my rangefinder on the stalk as well. I have an aluminum stalk and the metal rangefinder made by i think it was atomic...something or other lol.

There is a slot on the rangefinder for screws but how the heck do i drill holes in the stalk that small?
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top