Any ide how to fix it ?

TD7614

Jr Hunter
Any idea how to fix it ?.
How could straighten out around the ears ?
A helmet made of lightweight PVC 2 mm and ears made of the resin.
I thought of the unfolded state in hot water but I fear that the whole shape of the helmet can bend

IMG_0443.JPGIMG_0441.JPGIMG_0442.JPG
 
Last edited by a moderator:
I made helmet from different templates then ears so looks strange. I use my oven, but it was wrong decision, so now I have much more work to do whit repair helmet.:cry
d85ca44eb5c760d2.html
 
Last edited by a moderator:
I would use some bondo to fill the gaps between the ears and the helmet. Then sand it smooth and primer it. Have a look where to tweak a bit and if you like insert a fine small line that normally is between the ears and the helmet.

That´s what I would do. Hope it helps brother.

:)
 
I've come across this before, heat the ear up and shape it to the helmet. Once it is painted, you will never notice it.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top