Alternative wiring for TF stalk

terminal fettler

Active Hunter
Heres the method i used recently on my stalk and helmet...
-Firstly i dremmeled the arc into the inner ear peice
-Then used this as a template to modify the helmet
-Then attached the stalk and marked the position of the hole on the stalk shaft
-Make sure the hole is dremmeled rather than drilled using a fine tool rather than drill bit, this will ensure the carbon dosent splinter, just big enough for the two wires to fit through
I'm quite happy the stalk retains most of its strength after this mod...

DSCF0019_10.jpg


DSCF0004_42.jpg


DSCF0005_35.jpg


DSCF0017_8.jpg
 
Thats what I had to do with my ROTJ helmet. TeamFett got to see what happened with mine... when I screwed the bolt on the screw driver striped the wires shorting out the LEDs. :(
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top