Hey, all! I'm looking for advice on affixing the visor to the inside of the helmet. I have an old Don Post (94 or 95, I think?) that I repainted and cut out the plastic so I could add a proper visor.
I originally had a thick plastic visor that I had gotten off eBay in there. The thing was a pain to cut to size and never really fit properly. Plus, it was a black tint instead of the proper green. So, I got one of the dark green visors from RJSafety.
The new visor arrived yesterday and I have it cut to size. I pulled the old one out and I am ready to put in the new one. The old one I had fixed into place with 2-part epoxy putty, but I don't know if I want to use that again. It's a pain to work with, and it's really hard not to get it smeared all over the visor because it sticks to your fingers when you're kneading it together.
So, what do you guys recommend? I doesn't seem like hot glue would be strong enough to hold it. What about super glue, or some other adhesive?
Thanks!
I originally had a thick plastic visor that I had gotten off eBay in there. The thing was a pain to cut to size and never really fit properly. Plus, it was a black tint instead of the proper green. So, I got one of the dark green visors from RJSafety.
The new visor arrived yesterday and I have it cut to size. I pulled the old one out and I am ready to put in the new one. The old one I had fixed into place with 2-part epoxy putty, but I don't know if I want to use that again. It's a pain to work with, and it's really hard not to get it smeared all over the visor because it sticks to your fingers when you're kneading it together.
So, what do you guys recommend? I doesn't seem like hot glue would be strong enough to hold it. What about super glue, or some other adhesive?
Thanks!