stripping paint of a helmet?

i stripped down 2 helmets using acetone.

the master replicas helmet had no issues. the one made of smoothcast roto was 99% ok, but the keyhole area melted a little... i had already cut them out, so there wasn't much left back there. it was easy to fix, but there was some damage.
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top