Standardized Fett helmet measurements

Please, let's do away with the english system, and have ALL measurements in Metric?

Geez, I was going to suggest we use an ancient traditional Japanese measuring system (a specific iteration used during the Edo period), but you seem so strongly in favor of metric, I guess we should go with that. :lol:

Seriously though, whoever comes up with measurements in one system, someone else will probably post a conversion of it. I'll start. The circumference of my Sgt Fang mystery is 2.389 shaku. Anybody? :lol:
 
Let's all use parsecs!!!

Ok, so 1 parsec = 30856776000000000000 millimeters
and 1 parsec = 1214833700787401700 inches

Seriously, people should use whatever system is easier for him and then, we can make a conversion...

This would be for the Don Post 1996 version :

* Width/Depth of the bottom opening :
-Front to back : 240mm/ -Left to right : 235mm/

* Circumference around the red mandible stripe :
-Left ear to right ear (front) : 310mm/ -Left ear to right ear (back) : 334mm/

* Distance from bottom back to top of dome (perpendicular height): 220mm/

* Distance from bottom front to top of dome (perpendicular height): 260mm/

* Distance over the top of the dome (under the triangles) to the back ( over the keyslot) : 350mm/

* Location of the dent :
Height from bottom of visor : 215@235mm/
Left/Right - Center of arrows to dent : 40@60mm/
Front/Back - Front of mandible to dent : 20@40mm/
 
Sgt Fang Mystery Helmet dimensions (as measured by TK-409)

Overall, Dome
Helmet height: 240 mm
Circumference without left ear: 724 mm
The Dent: 25 mm x 25 mm

Visor
width at the top: 48 mm
width at the bottom: 45 mm
Eye slit height at the left: 7 mm
Eye slit height at the right: 7 mm
Eye slit brow to mandible height near the center: 20 mm
Eye slit width: 272 mm

Cheeks
Left cheekbone height: 113 mm
Left cheekbone width: 115 mm
Right cheekbone height: 106 mm
Bottom cheekbones width: 10 mm

Left cheek height: 82 mm
Right cheek width: 122 mm
Right cheek height: 76 mm

Left tooth height: 142 mm
Right tooth height: 145 mm

Borden connector: 9 mm diameter

Ears
Left ear width: 43 mm
Right ear width: 40 mm
Right ear foot height: 15m

Brow
Brow top height: 11 mm
Temples width: 27 mm
Left brow height 40 mm
Right brow height: 36 mm
Each forehead arrow: 12 mm wide x 6 mm tall
Height from brow to arrows: 8 mm

Back
Left back height: 118 mm
Center back height: 111 mm
Right back height: 122 mm
Key slot section width: 45 mm
Key slot section height: 101 mm

RF
RF stalk: 187 mm
Rangefinder width: 73 mm
Rangefinder height: 25 mm
Rangefinder depth: 37 mm
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top