Making Ironman: Helmet

ironclover

New Hunter
Making Iron Man: Helmet

So about a month ago I had the wierdest inspiration to begin a new project, unlike anything I have ever done. I decided to mold a helmet, then cast it. After casting I will put even more detail into it. The helmet chosen for this feat in none other than the helmet from the new Iron Man movie. Here are the first progress pics.

Iron%20Man004-1.gif


Iron%20Man005-1.gif


Iron%20Man006-1.gif


Tips? Concerns? CC?

IC
 
Here are more updated pics.

I had to basically restart because it would have been too small...

DSC00244.gif


DSC00243.gif


DSC00242.gif


DSC00241.gif


I think it is turning out alright...
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top