Kotobukiya Jango figure, Why is it sticky?

slave1pilot

Well-Known Hunter
I have a Koto jango that a friend gave me.
it was already opened when i got it a couple years back
424557173fzwXMj_ph.jpg


Problem is, the flames are sticky to the touch
Anyone know why?
Or better yet, how to make them "unsticky"?

It'a only the flames, the rest is fine
 
If it is sticky in your display case, try brushing talcum powder on the bottom, that will take out the "stickyness" and wont tarnish your display cases bottom, or shelf, or whatever you are setting this on. If you brush it on the flames, the sheen might be taken out. I guess as long as you are not touching the flames you are good to go and dont need to take out the stickyness. Maybe the resin they used didnt fully cure on that part?
 
true it might but i believe the "elephant in the room" is, if this is a display, why are you or other people touching it. if no one touches it who's gunna be the wiser?
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top