input on project needed

Scoutleader

Active Hunter
One of many distraction in the world is making hike staves/staffs to use on backpacking/hiking outings or when I go "play" Scout.
The past few weeks during "down time" at work I have been working on some pieces that could be placed on a hiking stave/staff.I am at a good stopping point until I figure the next phase of these creations.Please veiw the photos and share your input.
This pieces are completely metal except for where I "dressed" my welds in joining the metal together to give it a smooth look using polyester filler.

This is of both pieces after a coat of aluinum paint was a applied.
IMG_9594.gif


IMG_9601.gif


IMG_9600.gif


I plan on doing some more painting to them with maybe some weathering and layering of different colors.Which is where your input is needed.
I had thought of making two staves/staffs with this pieces but I am thinking of making one using them both,a top and a bottom.Again your input to help
I am currently working on a piece "like" a Maul saber where two pieces will join to form one piece for a hand grip in the center of a hiking stave/staff.
If needed be I can show some better photos on a few days.I took some during the building phase.
Anyway.... thank you to all comments and input
 
Okaaaaayyyy!!! Those look bloody dangerous to me. Nice metalwork though (y). Still you could take someones eye out if you're not careful. Or remove the small collection of dangly objects in your trousers. :lol:
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top