i need the basic run down of creating a mando helmet

killjoy

New Hunter
ive seen people use a paper template to start the process but i dont know where to find it. i know that u need bondo, resin and fiberglass to start the helmet i just need a basic rundown of materials and what the steps are. i would appreciate any help
 
Hi Killjoy and welcome to the site.

Your best bet would be posting some sort of introduction thread and then doing a lot of reading through the sites old posts. There is a section that is completely devoted to making helmets. Using the search function is your best bet. Try doing a search for "scratchbuilt helmet" and seeing what pops up. There are probably hundreds of threads with dozens of different methods and materials for making helmets.

Good Luck,
Jack
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top