How to attach plates to the vest?

mapegothe13th

New Hunter
Hey, im making some armor using the trashcan armor method and i was wondering how to attach the armor onto the vest. Also, what is the vest? And were can i get one? Thanks :confused
 
Bolt on is the most effective I think (and use)... the only problem you might have is trying to epoxy bolts onto the plastic from trashcan armor. Some plastics may not take some glues too well. You just have to experiment.
 
I used screw to attach my ammo, you just need to be very precise, and you wil have a ammo very resistant, check my album: Premiere of my Jango Fett costume......... in my account and see the results:
http://www.thedentedhelmet.com/members/snowaure-albums-premiere-my-jango-fett-costume.html

This was the initial construction..............

chest back.jpg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top