Yup, another build - My ESB

Boots by MoW

Wow... thee were shipped SUPER quick ... Thanks MoW !

12675151_10208557884167424_28519175_o.jpg


Attach28307_20160212_142204.jpg
 
Nice , they look smaller than that I have women's feet , size 7 UK and can't find anything suitable . It's so depressing my build has stalled because of it
 
I need to order a pair of MoW's boots!


Nice , they look smaller than that I have women's feet , size 7 UK and can't find anything suitable . It's so depressing my build has stalled because of it



I was thinking of getting some Blundstone canvas boots and then modifying them and dying them but by the time I finished I may as well have got a set of MoWs.... luckily his smallest size is my shoe size otherwsie I'd be in your same position.
 
Nice , they look smaller than that I have women's feet , size 7 UK and can't find anything suitable . It's so depressing my build has stalled because of it
I've seen some great conversions come out of regular slip on shoes with canvas added. I think there was even a build thread here!
 
I just got a progress photo on my helmet.

It's a cold cast aluminum cast that is from WMB Custom Creations who consists of and was sculpted by Rob Miller who was on last seasons FACE-OFF on the Sci-Fy channel and fellow Great Lakes Garrison member.

Still needs to be buffed out:

received_1239562046057523.jpg


12744763_1709202642650118_2967828209007275173_n.jpg
 

i would have had these but I don't think they are wot they say they are ! The listing says ca boots but the image is of MOW first run of boba fett boots that were made of canvas . I have messaged the seller a few times asking for more pictures but they haven't replied . Which is a real shame . Thanks for thinking about me tho I really appreciate the thought
 
Great start. I have the same set of armor, as well. Just finished taping down my lines/edges and plan to finish trimming and clean up this weekend.

How do you plan to cut out the slots for your chest display? Are you using a stencil get the exact location/size?
 
Great start. I have the same set of armor, as well. Just finished taping down my lines/edges and plan to finish trimming and clean up this weekend.

How do you plan to cut out the slots for your chest display? Are you using a stencil get the exact location/size?
Actually, I cheated and have sent my armor to AFettFullof$$ and commissioned my paint job.

[emoji13]



Sent from my SM-G928V
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top