WoF template printing help

christssoldiers

New Hunter
I'm hoping someone here can help me sort this out as it's driving me mad. I must have printed the "scale" page, the one with the 5" by 5" rulers from the WoF templates 100 times and I cannot get it to measure corretly. I have tried every setting I can think of with no luck. I finally tried it again on a different printer, this time a laser thinking that my ink jet was the issue but the results are the same. Every time I print this page the 5" grid measures short by anywhere from 1/16" to 3/16" depending on the settings I use.

It would be extremely helpful to me if someone who is able to print this page so that when measured with a ruler it comes out to the correct 5"x5" size could tell me what settings exactly they are using, or even screen shot the settings for me.

Here are the settings that get me the closest to accurate but I am still losing about 1/16" over the size of the scale. I think this is why the last helmet I made was just a tiny bit to small for me.

settings1.JPG


settings2.JPG


settings3.JPG
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top