WOF ESB Gauntlets

Thread starter mkshane81
Start date Feb 3, 2010

mkshane81

New Hunter

Feb 3, 2010

Okay, this question comes from being a noob at scratch building. I am assembling the top half of Alan's left gauntlet. If I am wanting to make this wearable, and durable at the same time, should I do any kind of reinforcement on the inside as I go? i.e., resin, expanding foam, etc. Any input would be extremely helpful. Thanks in advance.

-Matt

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.