wizardofflight's Boba Fett Blaster and Shin Tools Templates

NOW here is a clear indication, that there really NEED to be made sticky.!!! And a splendid thing is that they ARE!!! Finally!
Just my two cents, Ville
 
Last edited by a moderator:
thanks for posting this asok, the ESB blaster prints will come in handy. I own a resin cast but would like to make one machined out of Aluminum (i'm a machinist and work is a little slow right now) I'll keep you guys posted on the progress.

B1
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top