WIP: Weathering my Evolutions Boots

Ponte

Active Hunter
Well, after slowly piecing my Boba Fett together (got a LONG way to go folks), I decided to use Spidey-fett's awesome boot weathering guide to make my brand spanking new boots into a close representation of the screen used boots. It's no wickedbeard, but it certainly looks alright being my first time using the acrylic paints.

Almost brand new, had to apply some piping along the middle:

DSCN1299.jpg


After some weathering:
DSCN1362.jpg

DSCN1365.jpg

DSCN1367.jpg

DSCN1368.jpg

DSCN1369.jpg

DSCN1370.jpg


I still have some more work on the soles and I haven't even touched the toe spikes yet. Plus, I need to remove some Gorilla Glue stains that got on the middle stripe of the boot (yeesh). I should have more work done by tomorrow.
 
Hello, your boots look awesome, I have just started my suit, a few soft-parts only, but thinking about doing the worn ou finish, where can I get to the guide that you mention?

Thanks, regards
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top