Widening the WOF templetes?

Hello guys,

My question is this: Is there any way to widen the chest, ab, and back templates from WOF? After looking at the pics of the armor I made last year I think I used the wrong size templates. I'm about 5'9/ 5'10 so the large should be OK... It certainly is the case with aluminum back armor I just made... BUT... I think it may need to be wider so it wraps around me better.

Is there a trick I could do with my printer when I print the templates? or should I just cut the chests, ab, and back down the middle and insert a 1 or 1.5 inch strip? I appreciate any advice.

I just posted two pics of me in an ESB showoff thread if you want to see what it looks like now. Thanks!

Are you talking about immensely wide or just to the where the standard prints come out small? LOL sry...

Only thing I could suggest aside from trying to redo the whole page width, aspect ratio, layout, finish, yadda yadda, yadda thing is say print off 2 identical left chest plates, cut it in half diagonally, tape a blank piece of paper behind them and kinda fill the gap in with a pen as close as you can, and do the same for the remaining pieces...

Edit: nevermind, posted without reading to the end, I'm a dumba**...

But still, I would go the "filler" route if your printer won't accept any layout changes that accomodate you...