What to use for Toe spikes

TactKor

New Hunter
Anyone have a recommendation for what can be used to make a good set of toe spikes?

Or can anyone provide the length and diameter that they should be.

And finally do these pose any weapons problems at Con's
 
If you're going with the selfmade option, you could also follow Bobamakers tutorial here bobamaker: Aluminium Toe Spikes
i followed it myslef, but used wood dowels instead of alloy for the spike's themselves,i just pared them down with a pencil sharpener, angle cut them, used epoxy putty and a screw from the back/unseen side of the bar.
this is how it went 1st toe spike set up.jpg 1st toe set up 2.jpg
and this is how they turned out 1st toe setup 3.jpg the diameter of the dowell is 10mm. hope this helps, good luck
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top