What parts from the Ever Ready Minilight and Battery are you wanting?

asok

Well-Known Hunter
Now that I have my Minilight, I am going to mold it up. Are you looking for just the button or the whole thing? I can do either but, I want to make what people want.
 
I would say just the button. However, I would want to make the light functional so the end that holds the bulb might be useful as well.
 
Asok, did you try to put the mini light into the right gauntlet? If so, how well it fits in that particular area? I think the minimum part needed for a working light is the front part (the white sections) which includes the casing with the button and also the internals with the light bulb and half part of the contacts for batteries:

IMG_0376.JPG

Thanks again for boba trooper for the images.
 
That's a good point, FettFanatic. A cast of the bulb housing might be worth throwing into the mix. Heck, even a kit of the internal parts (the plastic block that holds the switch contact plates and bulb) that might fit into the insides of the gauntlets may be worth looking into.

I stripped out the parts from an LED mini flashlight and added a sliding microswitch that will fit through a hole I dremeled into my gauntlets. I'm going to epoxy the 'button' that came with my MOW gaunts to the tip of the slide switch. Hopefully it works out.
 
Asok, did you try to put the mini light into the right gauntlet? If so, how well it fits in that particular area? I think the minimum part needed for a working light is the front part (the white sections) which includes the casing with the button and also the internals with the light bulb and half part of the contacts for batteries:

I did take that apart but, I don't have gauntlets to test it in. I lost those when I lost my job a few years ago. Not sure if I can cast that whole part but, I will look into that when I get home.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top