What glue?

Coyote850

Active Hunter
I wanna use snaps to attach my armor to my vest. What glue do I use to attach the snaps to the armor? The armor is Fiberglass. I was thinking Gorilla Glue. Lookin for input.
 
I would attach some pvc to the back of the snap, and sand the back of the pvc and the armor to give it a good hold. You could use goop, epoxy, or anything strong should do the job. I used goop and attached magnets to my armor.
 
Yes, attach the snap to a small piece of pvc or abs, lightly sand the two surfaces that will make contact (NO paint, oil or dust) Devcon makes several types of 2-part epoxy that work great. You can find it at OSH or Wally World.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top