Webley...Rubber EE-3 Blaster

Oooh. Look at this. I tried the ROTJ cone on the Rubber Webley...Perfect fit. Squeaks as you push it the full way on. Wow.

Webley%20with%20cone%20002.jpg
 
Here are some pictures of the connectors for the ESB version. I molded real connectors, machined them out to be molding friendly.

LOL. <speaking like a tour guide> And in the far rear you can see a casting of the Minority Report shotgun. And in the middle a casting of the Minority Report Spider.

sBoba%20ESB%20blaster%20progress%20shots%20016.jpg

sBoba%20ESB%20blaster%20progress%20shots%20012.jpg
 
Last edited by a moderator:
The side "rings" will probably have to be closed instead of pass thru as shown. I doubt that the rubber will flow through that small of an opening easily.
 
The connectors are molded from the Molex connectors. I molded the originals, cast them in pour-a-cast and then machined them out to give back some of the detail. The grey is due to trying to add some black pigment to the pour-a-cast. It didn't come out black as you can see.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top