vac pulled v's fibreglass noob question

Ausar

Jr Hunter
can any one enlighten me on the differences between these two construction methods and the final result pros and cons of the two
 
Depending on the item you are making, a fibreglass object has the best potential for maintaining defined, sharp lines in an object whereas a Vac-form is much easier, lighter and cheaper.

Fibreglass is also usually less flexible than vac-forming (depending on the type of plastic used).

For something like the chest armour, both methods are fine and it all comes down to what you want to pay and what is available to you at the time.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top