Totally off topic but...

Demonchild

Active Hunter
Its me again Im going to work on my cadian armor later but im workin on gili suit now :lol: and i was thinking should i use a camo green or a brownish color even though the burlap is already a brownish color but i dont know how to put the other strips of burlap on i was thinking gluing but the glue would go through and on to the table :eek: but then i can always stitch it :wacko but im still pondering is a gili suit more of a vest and pants like thing or is it more like a cloack? help would be nice 8)

from leroys brother justin :)
 
Last edited by a moderator:
well this is my sniper rifle i made 8) its not paitned yet but its getting there the reason the stock is kind of messed up is because when i was cutin the board to smooth it out the blade snaped so what do you think i should paint it a came green? or black with a mix of camo green?
constructed from 2 dalrods, really big paper, lots of tape,screws, and wood.

from leroys little brother justin

sniper.jpg
 
Its a start. Looks good so far to me. I think i would go with more of a gunmetal or weathered black look though

dan
 
DONE! i painted it and added a scope to my sniper rifle i had it done the day i made dis post and but i was to lazy to post it well here it is.

gun2.jpg
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top