Toe Darts? Does anyone make them?

Ok, cutting the angle is pretty easy. I just held one under shoe, eyeballed the angle I wanted to cut them at, marked it, and then cut it with a hack saw. If you don't have a hack saw, a dremel should work too.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top