Toe darts

Fettism

Hunter
Well I think that's it :cheers .... now I just need to beat the boots up a bit get em all dirty maybe fray a few edges . Have I left anything out ? I might try to fill in those wee gaps between the bracket and the boot .



Mike

Darts boots FRT.JPG


Darts LF boot.JPG


Darts boots  B view.JPG


Darts boots RT side.JPG
 
One of the cleanest jobs I've seen. Excellent work, now it's time to get them dirty! Saving these shots for future reference.

Thank you for posting.

Alan
 
you should were them suckers in Wall-mart
_______________________________________________________________________
if your freind Jack is on a plane never yell out hi- jack
 
Yes got the tips right here on TDH .. thanks to all (y) . I took 3/8" aluminum rod and into the drill press with a coarse & fine file Hacksaw on an angle drill , tap and that's all folks (y) !!!


Mike
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top