for those who have used sintra for thier armor

Boba Freekk

Active Hunter
what thickness did you use for:

chest armor
knee armor/shoulder bells
back plate
gauntlets
codpiece

im in the process of ordering sintra from US plastics and i want be sure of the thickness before i place an order.thanks:D
 
I used 1/8" for all of my sintra Armor pieces.
The cod has 2 layers at the front area to build it up.
As well, I have vacuformed styrene gauntlets, not sintra.
 
thanks guys!!!

the site list thicknesses in decimal form,.120 is closest i can get correct?because 1/8 converted to a decimal is .125

now i feel really dumb:facepalm!!!!!!
 
I used 1/8" Sintra for: Chest armor,shoulder bells,back armor,
cod piece, and knee armor. The 1/8" Sintra is easier to work with than 1/4" Sintra......invest in a Dremel tool and heat gun before anything else.
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top