Template for flat shape under the ESB flame thrower?

This probably isn't 100% accurate or the right size but I'm posting it here to get some feedback on what everyone thinks.

ESB flamethrower temp.jpg


You can use it if you want but like I said, I'm mainly posting it to get feedback so I can improve it.

Any comments/suggestions/feedback?
Thanks. :)
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top