Suggestions for back panel of Jet Pack

I cut a piece of sintra and drilled a hole in it big enough to stick my finger in for easy removal.

Then I put a few very small strips of Velcro around the lip of the opening.

Seems to work fine so far.
 
Last edited by a moderator:
On my MOW pack i cut a piece of 5mm plastic card slightly over size then sanded to a precise fit, bottom edge in first then tight to the top so no fixing required, just requires a penny to pop it out...

DSCF0015_10.jpg
 
Last edited by a moderator:
I have a peice of sheet metal cut to size, with magnets at each corner holding it in.

jetpack_rear.jpe
 
Last edited by a moderator:
I've just done my Geonosis Jango JP Pannel.

0.8mm mild steel, held in place by 1mm (STRONG) earth magnets, then covered in Rub N Buff.
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top