Slot dimensions and Fettronics light boards

Fettronics

Active Hunter
I had a question about this, so I thought I would send out a post to see what others thought.

In one of the older posts, slot dimensions for the TK409 boards were

Length of slots: 48mm
Height of top slot: 5mm
Distance between slots: 7mm
Height of bottom slot: 9mm

I think the Shackman and TK409 boards use the .3 inch segment displays. My boards use the .39 inch segments displays.

My board dimensions are

Length of slots: 50mm
Height of top slot: 5mm
Distance between slots: 5 to 9mm (normally 8mm)
Height of bottom slot: 10mm

The screen used version cut the last character in half, so getting the slots cut at the 48mm wide dimensions would be screen accurate.

My question is, what dimensions are the armor makers using? Has anyone who purchased a Fettronics board had trouble with the slot sizes?

Jon
www.Fettronics.com
 
It's a bit late in the day now, but I'll measure mine tomorrow. I've got BM armour and was planning on buying one of your boards at some point in the future. All I can say about the slots at the moment is that when he asked me how I wanted the slots done, I asked him to do whatever he thought was closest to ESB.
 
I cut my slots to your dimensions. They look very accurate, comparing to ref pics. Hope to order one of your boards after the holidays.(y)
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top