slave1pilot's ROTJ Boba Fett costume Version 2.0 WIP

Thanks guys.
My own costume is on hold because I have a commission that takes priority. I don't have my parts anyway, so it's ok.
The gauntlets shown above were sent out to another TDHer that was on a much tighter schedule than myself- so I am waiting for replacements.
Also, the armor above wasn't up to my standards, so it went back to the maker -I am still waiting on replacement set.

On a more positive note, I dyed my Girth today
girth001.jpg

I'm sorry for the lousy pic,
but it's sitting on a few yards of grey Tackle twill that is waiting to be sewn by crazy4bobafett (the greatest seamstress in all the land;))
 
How did you dye your girth. And this thread is like my wet dream. Everything has the top maker's brand name: Fettronics, Fettpride and all the top names in the game. So very jealous my friend :)
 
Thanks guys.
My own costume is on hold because I have a commission that takes priority. I don't have my parts anyway, so it's ok.
The gauntlets shown above were sent out to another TDHer that was on a much tighter schedule than myself- so I am waiting for replacements.
Also, the armor above wasn't up to my standards, so it went back to the maker -I am still waiting on replacement set.

Just an update...
I am still waiting on my replacement armor and also the replacement set of guantlets.
Apparently, I sold the gauntlets in the Cargo Hold in hopes of getting a newer version in a timely manner.
I thought I had sent them to another member, but I have been corrected.
The armor was replaced, but THAT was sent to another member and has not been re=replaced yets.
it's all very confusing because it was so very long ago .
Regardless of what was sent where, I'm still without hard parts (except the helmet) so I am unable to proceed.
 
Another small update
it's been 6 weeks since my last post, and still no hard parts from fettpride and no indication that he will ship any time soon

However, i did receive this today...
bobaversion20064.jpg
 
Last edited by a moderator:
Hey Slave1pilot! I love the work you've done on your ROTJ style Fetts (I'm working on one myself so this is great inspiration for my work!)!

Question; that would be Fettronics' V3.2 LED display right? If so, what dimensions would I need for the breast plate window to frame the LED display?

Again, great job! I look forward to seeing your Fett completed!
 
I finally received my armor parts from fettpride today.
bobaversion20065.jpg

if you wanna know why I say "Finally", go here http://www.thedentedhelmet.com/f33/what-does-fettpride-owe-you-44340/
and pull up a chair for some light reading ;)
You'll notice the bottom of a flamethrower in the pic.
I needed it that part 4 months ago to complete a commission ( I bought the gauntlets from fp 8 months ago, but that part was missing) but it didn't arrive until now, so it's useless now since I mailed the completed commission out 2 months ago..:rolleyes


I still need to source a reliable vendor for gauntlets and a jetpack, but i intend to start on the parts I do have after SDCC in 2 weeks.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top