Sintra Made Knee armor pics

dgasser

Active Hunter
So a few years ago is when I started this project and I'm finally getting a push from Seeker to get it going so I'm posting some of my stuff I had done.

Here are some pics of my Knee armor I made completely out of Sintra. My brother wanted to try to paint it so I had him have a shot at it but I'm going to do it again. Some work needs to be done with them but they are pretty close for just eye balling them with out a template.

The nozzles are just a pvc joint connector cut off a bit to make it look pretty close. The item is pretty light and durable.

bf_knee1.JPG

bf_knee2.JPG
 
I used balsa wood and bondo on mine. Yours look better, I think. Nicely done (y)

Color looks a little too orangey though, or could it be the flash...?
 
Thanks for all the positive feed back. The paint job on these are correct yet.. I was playing with the color. I'l be resanding them down and doing them again.
 
Very nice , they look like my firs set of syntra armor I made.
Using putty truly helps achive the correct look to your taste.
Good job.
 
The paint I used was from Fleet Farm and I think it was Tractor Yellow paint. I'll find the paint and see who it is made from.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top