Sintra?

Broadway204

New Hunter
Because I have never used Sintra before I was wondering if you can glue up pieces before forming or should it be done after forming?

Thanks
Richard
 
i´m guessing that if you use a glue that melts the pieces together, like ABS cement does, it should be fine. Whilst other types of glue will "let go" when heated up.
 
The only thing i found that may be a problem is depending on how you are gonna heat up your sintra. if you boil in water should work. but i have found that if you are gonna try to use a heat gun it may warp around the glue. Chemical / heat reaction? just my 2 cents. But I did some glue work also. keep us updated on your build
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top