Sidewinder ESB kit

Callista

Active Hunter
This is my new EE-3 Sidewinder kit, looks great and is excellent quality...I aint sure how to put it together though (i mean yeh it odvious which bits go where but what glue and screws...I have no idea). Anyway this is my next project to do....so any comments or advice yo0u can offer would be great!!

Sidewinder2.jpg


Sidewinder1.jpg
 
Epoxy glue like araldite works fine with resin and is very strong for larger parts , for smaller pieces super glue is easier to use .Parts that require screwing together like the stock to the grip etc are best done by pre-drilling a smaller hole than the screws which will then make their own thread into the resin.Try and use slotted screws, as opposed to phillips, as they will look more authentic

good luck :)

Steve
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top