SHOW OFF all aluminum ROTJ Fett

Arakus

Hunter
Another round of upgrades puts this rig just north of $4000. Aluminum Durasteel armor and helmet added just the right touch:

P1010106.jpg


Helmet -Hand Shaub aluminum helmet painted by TK 7602, custom LED circuit board bymrgr8ness, Boba Maker rangefinder and hollow stalk
Armor - Durasteel aluminum armor, painted by Wickedbeard, aluminum cod blocks, Wickedbear metal armor knees and darts
Chest display - TK 409
Gauntlets - Wickedbeard metal gauntlets, painted by Wickedbeard
Flak vest - Boba Maker, weathered by me
Flight suit - Boba Maker
Girth Belt - Centaur Mohair from TDH
Ammo belt - cucublack
Side Pouches - Boba Maker
Gloves - The Real Gloves
Wookie Braids - real horsehair made by Slavefive a few years back
Cape - army tent material from TDH
EE-3 - Hyperfirm
Jet Pack - MOW Jet Pack, painted by Wickedbeard, aluminum beacon and stabilizerby Serenity, real U.S. Diver's buckle (not painted yet)
Jet pack harness - Boba Maker
Ankle Splats - Boba Maker
Shin tools - TDH
Boots - CA Boots
Toe Spikes - Boba Maker

 
Last edited by a moderator:
Wicked.

Although the gloves look pretty clean, or maybe it's just the picture?

How long did this take?

Took about 2 years to get all the parts. I did very little myself (pretty much just the weathering) and mostly just scoured the cargo hold here for stuff. Always upgrading though...
 
That's very cool. Any scratches, bumps or peeling are just going to make the armour more authentic. Was the armour shaped by hand or was it done in a press?
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top