shoulder studs!

CodytheSeparatist said:
So where do you find this particular item?...

A very cheap thing that you can do is take an old computer keyboard and take the keys off the board and use them for studs. That is what I did. You can repaint them to whatever suits you best, and bam, you have shoulder studs.
 
Jeremy's right. Specifically, you're looking for old adding machine keys, which are flat on the bottom, not slanted, like today's modern computer keyboard keys.

I recommend filling the inside of the key with Bondo, and setting a hexnut in place. When you run the bolt through your collar and back armor, the nut will secure the bolt.

Although there are some collar bolts sold on eBay from time to time, they are recasts of a TDH member's aluminum studs offered here a couple years ago. SpideyFett and I did a side-by-side comparison once, and got exact dimensions.
 
Batninja is right about the bondo and hexnut. I haven't been able to find any collar bolts on eBay at the moment, but I did find an adding machine with keys that would suffice.
 
Bobamaker sells them. You can also cut them out of wood. I lost one of mine and I just sliced out a couple from an old piece of 2X4.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top