Shin tool measurement?

Hi there, I've been thinking about building my shin tools. I am using the WOF templates and would like to know how thick the parts are for this particular tool. Could someone please supply me with the proper measurement?

Thanks.

Picture 1.png
 
it should be about 3/32nd" to an 1/8th". Don't go over an 1/8th" it looks to think. Looks like I need to make a revision.

Thank you goodluck with your build.

Alan
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top