shin pockets (Boba-ROTJ)

Here is what im using. Cant remember where I got it but I also got a jet pack harness blueprint, and one for the chest armor.
jthighpouch4.gif

 
Thanks, I needed those as well, but did they have the pockets for the shin tools as well?

anyone have any idea as to the size???
 
I had bought a life size standup and had my mom use that as a base pattern. She used a ruler and measured it and then fudged a little to make up for the size diffrence since i am only 5'9". It turned out fine and since i already had the tools that helped agreat deal also.
 
I have heard that one of the patterns that is floating around is too small to accommodate the tools. I would lay out the tools on the material, then just study a pic to get it close. At least the tools will fit!
 
I just measured mina and it came out like this- bottom is 4 1/8" the top is 4 3/4" and the sides are 6 1/4". This does not take into account for the part that gets folded under to be sewn. As for the pocket seperation for the tools I just put them in and had her sew it so they would fit comfortably.
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top