Seeking template for ESB EE-3 barrel holes

Timmer

Active Hunter
Hi everybody, I searched for a template for the ESB, EE-3 barrel end, to make sure I get the MPP flash holes fairly accurate, but no luck. If anyone has a solution to this, I'd really appreciate it.

Thanks,

Timmer
 
Hi Timmer,
here's a template for alan "WOF" Gif.
not sure if this is accurate as I've seen other mpp with an extra hole.
if you need any more info just type mpp flash in the search.

I can't remember who post up some very good ref's of the tube

seven also has a template from a Mr Mpp (PDF)

I made mine out of 38mm aluminium tube. I sanded n polished it up, after making the holes and am very please how it came out.

hope this helps

MPP_Flash_Tube.gif
 

Attachments

  • MPPFlash01.pdf
    26.5 KB · Views: 355
  • MPPFlash02.pdf
    29.3 KB · Views: 314
Last edited by a moderator:
Could someone with a real MPP do me a huge favor? I would like to know if these templates are accurate to the hole patterns in the real deal. If it is I may just get a piece of brass tubing drill the holes, do the letter stamping, and then get it chromed. Thanks.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top